Thin Client - 10
10.0" DSTN LCD
New Product!
|
Thin Client - 10 10.0" DSTN LCD New Product! |
|
|
|
|
|
|
10" LCD monitor |
back view |
profile view |
wireless keyboard |
| LCD Specifications | |
| LCD | Hitachi SX25S004 (downloadable PDF) |
| Dot Pitch | 0.0845 (W) mm x 0.2535 (H) mm |
| Resolution | 800 x 600 dual scan |
| Brightness | 100 cd/m2 |
| Power Consumption | 3.3V (typical) |
| System Specifications | |
| CPU Type | National Geode GX1 352-BGA package, VGA controller embedded in the CPU |
| CPU Speed | 200/300 MHz (300 MHz default) |
| South Bridge Chip | CS5530 052-TBGA Package |
|
Flat Panel Display Controller |
National CS9211 with 144 Pin LQFP Package (supports 2MB SDRAM frame buffer) |
| National Super I/O Chip PC87351 | 128 pin PQFP, PC98, and ACPI compliant super I/O that offers a single chip solution to the most commonly used ISA peripherals |
| Motherboard | IS751 |
| Touch Specs | Complete Touch Screen Solution. Built-in resistive touch with USB interface. Touch Panel's screen coder is using ScreenCoder II of USAR which supports a DSTN Touch Panel and uses the PS2 mouse interface as an option. Download USB touch drivers (3MB Zip file). |
| LCD Interface | DSTN LCD interface connector use 43 pins one (incl. 2 GND PADs). The slide potentiometers as a variable 10K resister to control contrast of LCD panel |
| LAN | National DP83815 10/100Mb/s Integrate PCI Ethernet MAC and Physical Layer (MacPhyter) |
| DOM | Disk-on-module on primary IDE (16MB DOM provided) |
| Compact flash | Can be configured for 2"-5" HD (not supplied) |
|
SO-DIMM Socket |
Size: addressing to 256 MB (default base of 64MB), Type: 100 MHz DIMM module |
| Bios Flash Memory | 256KB Flash Rom |
| LEDs | Qty 3: MSG, Connect, Power |
| Connections | 2 USB connectors (*), 1 RJ-45 connector (*only one USB connection when using touch) |
| PCI | One PCI Slot for low profile PCI card only, an ADSL card is bounded default |
| Output | 1 stereo headphone-out phone jack, driving an external passive speaker (1.1w to an 8 ohm speaker). |
| Power | DC 5V in jack (Delta ADP-25EB). Lower power support, 1.6V/2.0V operation with TTL compatibility on I/O pins. |
| Power Management Modes: | APM, CPU suspend command registers, suspend modulation |
| Weight | Approximately 5 lbs. |
| Drivers | TC-10 Drivers for Windows 98 (requires zip software): ethernet, motherboard, UDMA, Audio and Video |
| Dimensions | 11.4" W x 9" H x 2.3" D |
| TC-10 | $299 |
Limited quantities available.
|
FAQ's Q. How do I turn it on? A. On the back side of the unit, to the left of the modem connection, you will see a small button on the edge of the board. This is the power button. Push it to turn the unit on or off.
Q. How can I set up Windows 98 on the TC-10? A. Start with an HDD preloaded with WIN98. Once windows is up and running on the TC-10, go to the control panel and remove all hardware that has an exclamation point next to it. Reboot the system. When it restarts, windows will prompt you with "New Hardware Found". Then, install the missing drivers. Preferably install the drivers from a CD, or put it in a folder on the HDD. When prompted for the driver, direct it to the CD/ROM or folder. Then, if you haven't already, you may install the touch driver. |
|
Don't see what you are looking for? |
|
|
|
